FT220X – Full Speed USB to 4-Bit SPI / FT1248 Bridge
This USB2.0 Full Speed IC offers a compact bridge to 4-Bit SPI/FT1248 interfaces. The device is a FT1248 slave, capable of operating up to 500kBit/s, with low power consumption (8mA). The FT220X includes the complete FT-X series feature set and enables USB to be added into a system design quickly and easily over an FT1248 interface
Key Hardware Features
FT1248 serial parallel interface in 1, 2 or 4 bit wide mode.
Similar to an SPI slave in 1 bit mode
Entire USB protocol handled on the chip. No USB specific firmware programming required.
Fully integrated 2048 byte MTP Memory for storing device descriptors and CBUS I/O configuration.
Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
Data transfer rates to 500 kByte/s
512 byte receive buffer and 512 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
Configurable CBUS I/O pin.
Device supplied pre-programmed with unique USB serial number.
Supports bus powered, self powered and high-power bus powered USB configurations.
Integrated +3.3V level converter for USB I/O.
True 3.3V CMOS drive output and TTL input. (operates down to 1V8 with external pull-ups)
I/O levels from 1.8V to 3.3V. (5V tolerant inputs).
Configurable I/O pin output drive strength.
Battery Charger Detection. May be used by mobile devices to detect the presence of a charger on the USB port to enable higher current / faster charging of batteries.
Integrated power-on-reset circuit.
Internal 3.3V/1.8V LDO regulators
Low operating current of 8mA (typical) and USB suspend current of 125uA (typical) current.
Low USB bandwidth consumption.
UHCI/OHCI/EHCI host controller compatible.
USB 2.0 Full Speed compatible.
Extended operating temperature range: -40°C to 85°C
16 Pin SSOP and QFN packages (both RoHS compliant).
Dedicated Charger Port (DCP) detection enabling battery charging at higher current for faster charge times.
Inventory from our Authorised Distributors
Related Products
UMFT220XB-01 - FT220XQ Based USB to 4-Bit SPI / FT1248 Bridge Breakout Module
UMFT220XA-01 - FT220XQ Based USB to 4-Bit SPI / FT1248 Bridge Development module
